No, it is not currently possible to run a TryScript on any machine other than localhost. Instead what can be done is run a 1 user stress test ensuring that the TrueLog files have been enabled, choose a Queuing Workload test with zero simulation time, and ensure the following settings are enabled in the Active Profile: • The Stress test option is on. • The Stop virtual users after simulation time (Queuing Workload) option is off. • The Virtual user log files (.log) option is on. • The Virtual user output files (.wrt) option is on. • The Virtual user report files (.rpt) option is on. • The Virtual user report on error files (.rpt) option is on. • The TrueLog files (.xlg) option is on. • The TrueLog On Error files (.xlg) option is off. • The Compute time series data (.tsd) option is off. • All logging detail options (Results Logging and Results Internet Logging tab) are on. • The Enable all measure groups (TSD measure groups) option is off. • The Bandwidth option is set to High Speed (unlimited). • The Downstream option is set to unlimited. • The Upstream option is set to unlimited • The Duplex option is off. • The Modem compression rate is set to 1.0 x. After the test, the generated TrueLog can then be treated as the TryScript if required. Please note because of the extensive logging enabled TryScript timings should not be used to base target results, instead run a baseline test. There is also an RFE logged to have this functionality available in a future version of SilkPerformer. If you would like to have your details added to this RFE please contact Support.
↧